R/C Tech Forums - View Single Post - Clockwork Racing Engines and Products...
View Single Post
Old 02-14-2013 | 02:55 PM
  #6732  
McD44's Avatar
McD44
Tech Fanatic
iTrader: (16)
 
Joined: Apr 2012
Posts: 785
From: Kalamazoo
Default

Originally Posted by Maximo
What fuel ? what plug ?

also during breakin phases you need to tune in a 2 stage idle....when new they will not hold a low drop down idle......if its stalling it means you are pushing breakin too fast ! lapped or not ,stalling is usually it letting you know to back off a little bit !!! getting too greedy with the juice !!!!
LOL yeah, I'm getting impatient. I'll widen the gap a bit and fatten up the LSN. I ran three tanks through it with very fat settings only going to about 25% throttle. Two more slightly leaner and up to 33% throttle and then on the 6th tank I went for it a little. Engine was always pre-heated to 180° at the plug prior to starting. Only stalled twice but otherwise seemed great. I'll back off and run at least 4 more tanks with fatter settings.

Fuel is 30% O'Donnell Race Blend, Plug is a Nova #6. Didn't even think about different fuel = different settings...

Need to get some of that Bones Brew before the season starts. I'm just using up the 2/3 of a gallon of OD since it's sitting here.
McD44 is offline