^ up a couple of posts it said 2mm shims to get 3B. i haven't seeen any setup sheets for/from Exotex yet...
I have recently done the Exotek Duel Bellcrank conversion. I now have a huge amount of front end grip.
Unfortunately the car is now excessively Loose Neutral Power, will do a 180 no problem. I have tried softening the rear, stiffening the front (including swaybars), rasing and lowering droop on both ends, lighter oil in the rear gear diff (spool front), lowering roll centre rear – raising the front, rasing the front high and lowering the rear.
Im using sweep 32s on med grip outdoor asphalt
Has anybody else had this issue and were/how you able to sort it out?
*edit
Camber- F -1, R -1.5
castor - 4deg
tow F 1mm, rear 2.5 total
ride hight F 5mm, R5.5mm
droop 2mm all around
Thanks!
Last edited by Monsta; 02-10-2013 at 04:45 PM.
Reason: more info