Originally posted by Wap
Any new items, upgrades or etc. that I need to be aware about.
Hey Wap, welcome back.
You should be looking at the following stuff...
SER-802145 Servo lever front long S710+diffring
SER-802162 Middle shaft alu coated S710
SER-802212 Body-mount front long alu (3)
SER-802220 Bracket front up alu L+R orange
SER-802337 Anti-roll bar sets 2.5+3mm
SER-802362 Body-mount short rear aluminum (2)
SER-1388 Thrust-bearing 5X10 ceramic
SER-9607 Race brake-padset L+R
SER-802155 Bracket middle shaft alu
SER-802136 Bracket radioplate-support alu
SER-802552 Engine mount mono-block S710
SER-802241 Anti-roll bar levers + ecc. Alu
SER-802235 Spacer st-block-uprights (4)
You could also look at Thomas'
post on what he added to his 710.
BTW, I would suggest that you check the rear diff outdrives and the rear drive cups. Check to see if there is any kind of wear. You need to inspect closely in order to see it. If they are worned out, change them. That's probably the cause of the problem with the rear spinning out to one side.