Thread: Xray XB4 thread
View Single Post
Old 02-08-2013, 07:00 PM   #1540
annonymous
Tech Regular
 
annonymous's Avatar
 
Join Date: Aug 2009
Location: TX
Posts: 498
Trader Rating: 21 (100%+)
Default

Quote:
Originally Posted by asc6000 View Post
I too had a endbell bearing go out. The screws holding it to the can being missing didn't help. oh well.
Now you have me thinking the flex/contact worked the screws loose ( two piece can orion ).
The chassis contact is there I didn't think about it being that severe.
That is exactly my story, with the same motor even. I lock tite'd the crap out if those screws, and have had zero problem in the past two cars it's been in - the top two were perfectly right, the bottom two closest to the contact point were very loose
__________________
I drive faster on the bench...

Orion - Futaba - Savox - RCAmerica
annonymous is offline   Reply With Quote