Originally Posted by
Jeckler
When steering, or when rolling? Just the fronts? Did you try swapping front to back? To check the hexes, make a mark of the high spot on the wheel edge, then rotate the wheel 1/6th on the hex and check again. If the mark is still in the same spot, it's probably the wheel.
On a similar, I just ordered a set of 6 and 7mm hexes off eBay. I need at least 6 to clear the HPI vintage wheels I have.
http://www.ebay.com/itm/Cappu-Hex-wh...item2ec1a4b7ca
And TQ RC is taking care of my missing body post after Spec-R told me to contact them. Kinda cruddy, as it wasn't TQRC's fault it was missing.
When steering and just the fronts. Going to try the 6mm and 8mm hexes.