Help with 1/12 car
I was running my BMI 12rr today. I noticed that on my 2nd heat of the day and in the main my car would slow down quite a bit about midway and beyond. I have not measured temps over 150 on the motor - A Speed Passion 1cell v3 17.5t. I run a booster.. not a battery, battery for the car is a Turnigy 5000 40c new (1 month old). Gearing on a ozite med bite carpet was 88 rollout with a 78/47. 46mm on the rears. ESC is a old school GTB .
Seem to be fine first 4 mins of the race.. its the last half where its dropping off.. almost like a dumped pack.
Also on the endbell of the speed passion .. is there a specific A B C pin? or they just need to be the 3 phases of the magnets in clockwise direction.. if there needs to be a specific A B C .. how is it marked??
Also with brushless motors.. can you spray out the cans? what way do you clean them?
Thanks for any advice.
James