Originally Posted by
lidebt2
It looks good. Personally I would have added 1/2" more but that's me.
Should I redo the solder job? I don't want to damage the motor ESC.
Originally Posted by
CarbonJoe
For the motor wire connections at the ESC, after you tin the wires, but before the solder is fully cooled, flatten the ends with pliers. You can then fit the wires in the slots in the solder posts on the ESC.
I did this on my RX8, but the posts were so small on the RS Pro that I didn't think I could get them to fit. Next time I'll flatten them, some more to get them to fit
