Bought a brand new Speed Passion Cirtix Club Stock direct from the company. I'm trying to run a Novak 17.5 Ballastic motor. I have tried NiCD & NIMH batteries (don't have a 2S LIPO....yet
) as the instructions say the ESC will allow them.
Problem I'm having is that the red LED on the ESC keeps blinking, but nothing is happening with the motor. In one part of the instructions, it says the problem could be low battery voltage. Yet in another part, it says the red LED will blink continuously in normal use for this model only.
1. Batteries are fully charged.
2. Changed out sensor wire.
3. Removed sensor wire.
4. Calibrated the ESC.
5. Recalibrated the ESC.
6. Changed out sensor board on motor.
7. Changed out batteries & type of batteries (NICD & NIMH).
So, what else should I do/check? The wires on the motor are correct. A to A, B to B, & C to C. Sensor wire is hooked up, as the Novak requires it. I know the motor automatically senses whether you're running a sensored or sensorless motor.
Is it because I need to be running a 2S LIPO? Is the stator shot?
Is their a certain MaH required to power the ESC using different battery types? I'm currently using anywhere from 1500MaH-3300MaH.
Any help is greatly appreciated!!
