Originally Posted by
Kuya_Kimo
Do you run offroad blinky? Do you have the programming card? You'll have to load the v3_508 firmware for blinky. While you're at it, change DDRS punch setting to 9 if you have high C rated batteries. I also increase the brakes to 100% (esc) and use my radio to lower my brake EPA to feel.
The hobbywing ESC's are much smoother than the tekin's light switch feel.
High grip-indoor carpet-blinky-touring car.
I do have the card and pc interface software.
I can see the brakes being more than enough for offroad..Just a bit soft for the needs of carpet touring car (as compared to the rs). Again I may be missing a few settings in setup. I will post my current setup later today.I know anything to do with brakes/punch are at their highest setting...and from what I recall I am running the latest software in the esc.
edit*settings
mode 2-zero timing
forward/brake
reverse speed 100%
v.cutoff-disable
esc overheat-off
motor overheat-off
pr switch point 50%
1st punch 30
2nd punch 30
th curve linear
neutral range 4%
drag brake 0%
brake strength 100%
initial brake 0%
brake switch point 50%
brake rate 20
2nd brake rate 20
brake curve linear