Originally posted by Pro4Capece
Speaking of TC3 diffs.
Erik: Will the TC3 front spool fit in my Pro 4?
thanks
Im not Erik....but that would be very hard to get done as the TC3 uses Standard size bearings and the PRO-4 uses Metric sizes so unless you can get a bearing made that is standard on the ID and Metric on the OD you wont have a chance of using it. Not to mention if the outdrives are even the same size or if the spacing of the gear is even close to what it is on the Pro-4. Then at that rate you might as well just make your own out of alum....or buy the spool from TI Racing for the Pro-4 if you are in need of one that badly. Schumacher USA in FL had them in stock about a week ago.