Originally Posted by
SpecRC
Ok so i'm looking at some shims for the gear diff:
http://www.spec-r.com/default/index....roducts_id=161
Now this 0.1mm shim with a diameter of 8mm with a 4mm hole so its smaller than the original kit .2mm shim.
Would you put that under or over the original bigger 12mm shim?
I ask because would it get in the way or hurt the xring because of its size? Or could it affect the bevel gear because there isnt enough diameter in the shim for the gear to rest on?
I believe this is the standard 0.2mm shim:
http://www.spec-r.com/default/index....roducts_id=162
I'm looking to remove 0.3mm play, Is there any advantage to using 3x 0.1mm or 1x 0.2mm and a 0.1mm shim.
Help is greatly appreciated
Can someone lend some insight here?
Last edited by SpecRC; 01-23-2013 at 03:33 AM.