Originally Posted by
SlowPushin
Talking about the front lower arms you only use two 1m spacers ,one in front of the lower arm and one behind .
And to set the gap you loosen the suspension bracket push it forward then tighten it back. (Suspension bracket) part #804269 . Refer to page 5 , or exploded view of car
i saw that. part 804269. how can that part move forward if after you tighten the 2 screws, that part will move back again into its same position.i think i will sand down a 1mm spacer for it to fit. this 804269 has a set position that is dependent on where the screws put it.