Originally Posted by
B.A. Racer
some will say drive slowly on the street in figure eights. i just run them on the track and do some donuts on the track to scuff them in really.
Also can look into buying maybe the muchmore rubber tiresander and since TC rims are the same its a direct fit and just get some fine emery cloth or green scotch bright 600 grit paper and LIGHTLY make ur tire.. always better to do little cause u can always keep onsanding... ALSO MAKE SURE U KEEP GOING THE SAME WAY AND NOT TO ROTATE cause basicly u wanna round over the pin so it gives more tire surface on the ground...
OR also to break in the FRont can always put on the rear..
CAn a couple of you who tried most of the molded insert breack them down to charteristic?
like=
AKA= blah blah
proline blahbla
jc-1ext
jc-2
jc-3
SWEEP
Panthor