View Single Post
Old 10-23-2004, 12:06 AM   #852
Tech Elite
Boomer's Avatar
R/C Tech Charter Subscriber
Join Date: Feb 2002
Location: Southern Cal - Claremont
Posts: 3,346
Send a message via ICQ to Boomer Send a message via AIM to Boomer


You missed my point entirely. . . I merely commented on the fact that you are using non-stock parts and complaining about the fit.

Personally, I don't care what type of shocks you use and would really need a set of your shocks to put my hands on them in order to really see how they work. I didn't see any springs so I'm assuming you use the foam for both dampening and rebound. . .if it works, great.

But your shocks were not my point. From what you said and the answers that Bubbles, et al, gave, it wasn't the quality control that was at issue. . .

From my experience, it's rarely a materials error, especially when the error comes up in 1:100+. . . it's usually a user error. Usually MY user error!
RC10L2.5W - RC12.4 - RCNTC3(bmi) - TC4 (modded) - B44.2 - plus rent-a-rides! :D
Boomer is offline   Reply With Quote