Originally Posted by
eunique
awesome angle!!!
And which CVDs are you using? Are you still using bearing into bearing or spacer?
I'm going to have to place an order again! Lol!
I'm running Square 48mm R31 CVD's but I had to adjust the upper and lower arms to allow for the extra width 46mm shafts would probably be better for a narrow shell. I'm not using bearing in bearing now the CVD sits in the 10x15x4 bearing I used a tamiya oil bearing from a tt-01 the type that isn't actually a ball bearing, as a spacer inside the knuckle so it doesn't keep pushing the front bearing out of the knuckle.
Originally Posted by
eunique
Also, pickled, would you mind posting an overhead pic of how you have your steering servo mounted?
Originally Posted by
kwadruppel
Pulling the bearing through? Hmm, hadn't thought of that. After fully screwing in the set screws they do seem to lock the c-hub pins.
Thanks pickled.
No Probs
I just adjusted my toe out to about 2* from like 5* lol here is a pic now with less ackerman
I'm running Spice TE37's with 10mm offset on the front and 12mm offset on the rear but as my front track is about 2mm wider it equals out