View Single Post
Old 01-13-2013, 01:41 PM
  #672  
BeLiPoWa
Tech Initiate
 
Join Date: Feb 2012
Location: Spain
Posts: 22
Default

Hi, I have a 13.5T with a HW Xerun v2.1 120A ESC and it stopped working properly:

The motor works well sensorless, but when I connect the sensors wire, if the motor stops in a concrete position (always the same) it doesn´t start running again, however if I rotate it a bit by hand, continues working properly until stops again at the same position.

At first I thought it might be caused by the sensor board, so I have replaced it with new one, but the problem persists. Also measured the impedance between the motor terminals and they are correct.

I have tried too another motor with the ESC and it worked, and the LRP with another ESC, with the same problem.

I have no more ideas, so... anyone know what could be the cause?

Thanks.

Best regards.
BeLiPoWa is offline  
Reply With Quote