masterhit

iTrader: (16)

There is section 6.2. The only problem I can foresee is that depending on wheel spacers (or different track widths) they are really close to being past the tire edge. I did have some different widths cut.


6.2 BUMPER RULES
6.2.1 Bumpers are not required in all classes, but when used, they must be shock absorbing and non-metallic, with no sharp edges. For safety, rigid bumpers, such as fiberglass and composites, are not permitted.
6.2.2 Front bumpers must be of at least 1/8” material (3/32” for 1/12). Bumpers will not extend forward of the body except on off-road cars. The bumper may not extend to the side beyond the outer edge of the tires.
6.2.3 Rear bumpers must be made of a solid material with rounded edges and may not extend to the side beyond the outer edges of the tires, and may not extend beyond the rearmost part of the body except in off-road vehicles.