R/C Tech Forums - View Single Post - RC10 Factory Team GT???
View Single Post
Old 10-20-2004, 12:30 AM
  #66  
Wild Cherry
Tech Legend
 
Wild Cherry's Avatar
 
Join Date: Aug 2001
Location: TRCR Modified Driver
Posts: 22,595
Default

Originally posted by jbrow1
The arm carrers come 3 degrees. That makes 6 degrees toe in. The 1.5 hub carriers bring it down to 4.5 toe in. That's stock. Alot of people go with 0 degree hub carriers to get to 3 degrees rear toe in. That helps with any pushing problems in the turns. It's what I use. I think wildcherry has the angle mixed up in his previous posts.

He's talking about widening the rear. So if you don't use the T4 or B4 rear axel, you won't get a widened stance.

Sorry for the confusion Dmac & everyone....

* Stock Gt rear hub is 0 degree or 3.0 degree toe
* Team Gt comes with the 1.5 degree rear hub... 4.5 toe

Order the Racer`s Edge Hub for B-4 , be sure you get the 1.5 degree ones...... ( RCE9438>Stomer Hobbies)

Thats all I`m waz trying to say here....( I corrected the 3.5 mistake)
If you use the stock rear hub for the T-4 ,you get 3.0 degree toe.

With this set-up my Gt does not push, If you use the correct choice for the Ft tire.

I`m using losi 8 row, silver, well worn, with standard foam insert & Tangerine Tire grip.....used what tire works best for you....



Remember, use the Rtr axle for the T-4 or B-4( For Dogbones)
*use 7 thin Cvd shims on the axle before you install axle on hub, then use 2 thin shim`s & install the axle pin..

You cannot get the wider rear track with the B-4 rear axle spacer installed. So don`t use it....

Last edited by Wild Cherry; 10-20-2004 at 12:42 AM.
Wild Cherry is offline