R/C Tech Forums - View Single Post - xb4
Thread: xb4
View Single Post
Old 12-21-2012 | 12:04 PM
  #56  
john watkins's Avatar
john watkins
Tech Elite
iTrader: (17)
 
Joined: Jan 2010
Posts: 2,371
From: Tullamarine, Aus
Default
Originally Posted by BennyBagems
Got mine in the mail this morning.
Running LRP 8.5t with 21t pinion, will test it once I decide how to paint it.
Had to trim the little post 2mm to get the Sanwa RX to fit.
I will shorten the servo wire later to clean the install up a bit.
It's a great kit to build, almost a shame to put electrics in it looks so nice all new and shiny.















Looks good, Any build tips?, you know , all the little things you figure out after its finished? I might put my receiver in front of the motor just to make it a bit easier. I also noticed your running a low profile servo? I hadn't thought of that.
john watkins is offline  
Reply