Keven,
I have two touring car mod questions for you, if you don't mind
On the front lower A arm mounts, if the hinge pin had been flat before but you wanted to add some anti-dive by going to a mount that would raise the rear mounting point of the front arm, to the next higher mount....In your thinking did the roll center stay the same as before if no other changes were made?
Second question, also Mod TC. On a high bite carpet track as the traction increases, what would you do to help prevent the car from diving down in the front at the end of a long straight? The rear tire might be lifting. Do you have some suggestions.
Thanks Keven,
Steve