Originally Posted by
r450racer
Is it possible to get the Hudy pan car setup system to work at all?
If you can get 5x10 bearing holders to fit in the Hudy uprights then it could work. However it's set up to use the 1/8x5/16x9/64" flanged bearings of 1/12 and 1/10 pan cars front axles at the correct height.
I have both so it didn't cost anything to try it. The station isn't as useful with the F104 as it is for pan cars since the camber is set by which holes and side you use on the camber plate.