Originally Posted by
Kellen Guthrie
Shaving the u brace is essentially taking 2 ballstud washers out of the inside rear. It will raise your roll center which should give you less rear grip from the middle to exit of the corner. Normally when you shave the u brace you go to C hubs.
Thanks, yeah I already have the C-hubs installed, on the brace I run i have no washers and a lower profile ball stud that what the kit shipped with but learned of the shaving recently after seeing it in setup sheets and mentioned in here. Im very curious to try it out. I have so many different setup ideas I wanna try but not enough track time.....Man being a "newly wed" and ocrc literally 10mins away is a bad mix haha.
Originally Posted by
3srcracing
It would be cool if the staff on this site would allow us to make a new thread for we can have the new comers be able to look at the first post and find out all of the information that keeps getting repeated because it's not on the first page.. Oh well..
While I'm here, I broke a T plate.. How? Who knows... How do they usually break?
That can be done by the thread starter, I wish it would be maintained as well since I just got a b4.1 too and dont mean to bring up things that were talked about in the past.