Originally Posted by
M.Abramowicz
Hi!
What to do with tc6.1 c-hubs crazy slope????
I just put before race small 3mm screw from pinion and it delete that badly slop..
But that slop back now in badly big value again ...
AE made crap
in that place
So there is option to use better C-HUB with bigger hole for double joints shafts at front????????? From another car?
I like running the old c hubs. just dremel them out to fit a DCJ.
Originally Posted by
DesertRat
Would a bit of front kick-up and some rear pro-squat give you more rear bite? Right now I'm at zero pin angle at both ends.
I run up to 3mm of toe (3mm difference between the arm mounts, like 3.7*).. Add more rear camber or camber gain. If your at both of those already, take some front camber or camber gain out. It would be more helpful to see the rest of your setup to help