Originally Posted by
anthony_ling
hi guys, just built my MRX5, can you recommend a tool for the turnbuckel adjustment of camber, steering rod length etc... I have got-by with a bit of wire during the build but i'm looking for something for the job.. what do you use?
btw Enjoyed the build... very much looking fwd to getting up to brendale (Brisbane/aust) for a shakedown session..
Hi Anthony, I have found a nice set of tools for the turnbuckle holes check the photos.
You can find this kind of set for less than 5 bucks in any Chinese tool shop and they do the job perfectly. With the 90 degrees bent and the other two tools I can turn the turnbuckle from to any angle without any effort.
It makes the setup so easy, much better than hex turnbuckles.
