R/C Tech Forums - View Single Post - RcRenew.com engine resizing and epoxy crank re-filling
Old 12-10-2012 | 01:43 PM
  #1498  
Rcrenew's Avatar
Rcrenew
Tech Elite
iTrader: (9)
 
Joined: Jun 2010
Posts: 3,077
Default

Originally Posted by needknees
Lance,

The .19 showed up today, thank you for your prompt service and shipping! I'll be able to break it in soon in a relatively warm environment, hope to get enough fuel through it to run it this weekend. Only thing I am worried about is the temps this coming weekend will be fairly cold (~35F). Any tips on cold weather running other than fattening the tune up to compensate for the denser air? I don't want to damage this recently serviced .19.

I have another engine I can run that's in its prime, probably should leave that in for these cold winter series races...


No problem thank you

Just pre heat it before you start it and try to help it keep warm. ( leave comp heater on it or a sock or something for a few tanks) Thats about it. Keep it on the rich side until it breaks in and loosens up a bit.

Thanks,

Lance
Rcrenew is offline