Originally Posted by
hacker07
I am not sure that the rear shock angle should make the shock stick in any position. I use all of them from time to time and have never had any sticking issues. As far as a truck that is not rebounding, check the regular suspects...
-nut holding top of shock is too tight
-possible bent hinge pin but that is very rare
-sway bar set screws too tight (should easily wiggle back and forth)
-rear hinge pin holder too tight. (I see this more than you think)
Not talking about the 3 angles on the rear arm for the shock, I`m talking about re-locating the lower shock to the rear of the arm no longer using the slot that it normally rides in. The angle of the shock front to rear is the problem with rear re-bounding issues.