Originally Posted by
Slotmachine
The rear shock angle makes the suspension stick, if you remount the bottom of the shock on the outside of the arm with a longer bolt the rebound is much better.
Paul
I am not sure that the rear shock angle should make the shock stick in any position. I use all of them from time to time and have never had any sticking issues. As far as a truck that is not rebounding, check the regular suspects...
-nut holding top of shock is too tight
-possible bent hinge pin but that is very rare
-sway bar set screws too tight (should easily wiggle back and forth)
-rear hinge pin holder too tight. (I see this more than you think)