Originally Posted by
perez62682
i am talking about the n14 spacer. i do run it but i feel like that one it causing the binding when i tighten the wheel nut down. i guess my question was do you guys run the stock plastic one or like a brass spacer.
do you look in the manual for the part number or have them memorized? hahahaha
You must use the N14 spacer as without it there would be increased binding when the bearings are side loaded.
I have built nearing 50 of these kits not to mention how many tear downs and rebuilds I have done on my buggies over the past couple of years. So "Yes" I remember most of the part numbers.