R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 12-03-2012 | 08:07 PM
  #25056  
aeRayls's Avatar
aeRayls
Tech Elite
iTrader: (3)
 
Joined: Nov 2007
Posts: 2,257
Default

Originally Posted by Wildcat1971
yeah, I dont worry too much about the drivers or winning. I always treat a race as racing myself. I only care about my lap times consistency and my best lap time. My top 10 are normally 1-1.5 seconds from top to bottom. But my fast lap is not getting faster. Like i said maybe in practice I need to drive it like I stole it and try to keep my line. What really helps is racing against someone that is about your speed and you can push each other harder than when you just watch everyone lap you for the 3rd time , lol. I think breaking might be it also, I dont use direct breaks for anything but mid air correction and down side. I set 10% drag and never use break when all fours. I know there are advanced techniques of going balls out and breaking hard in the corner then square up and balls out again. and on high bitre tracks I can kinda do that. but I race on low bite. and anything more than 10-20% brake will spin you.
On low bite I typically put some roll into the car
aeRayls is offline