Originally Posted by
nwv327
if they are going to sell something as an ad on and not with the motor/esc kit then it should be clearly stated. and also they are not clear on if their is room to run an esc fan off the esc jst plug or if it requires the "mini" plug to work without having to run another plug to the receiver bec
The one touch set up is on the speed control. you do not need to buy anything else. you can wire a fan directly to the esc. it needs a two pin plug that usually comes with most fan set ups but if yours doesn't have it then you will need to add the plug.
As for your problem try plugging in a glitch buster capacitor to a receiver port. this helped mine when my servo was pulling too much power. my edge came with the capacitor but I have seen very early first run escs that did not have one.