I thought I would remove the crappy quality phone pics and put a few decent quality ones on instead.

I mentioned that I am not too serious about this chassis, I made it up just for a bit of fun really. It did go quite well at the club on Friday and will try it again with some better compound tyres on this coming Friday.

Next job is to slot the t-piece. The side to side action is really nice (the tweak screws at the front of the t-piece limit the amount of action, rather than adjust the tweak. The tweak is controlled by the small (front AE 0.18 springs) that sit nicely on the damper tubes), but the front to back motion is a touch too hard.

The spring on the centre damper tube just controls the pre-load of the pod when race ready.

So, nothing too serious, just for fun and here are some better pics:











Cheers guys :-)