Definitely not 70 - 80 degrees where I'm at! LOL!! Yep, I found Ron's instructions on page 1. I may have to wait until spring before I break it in. I just ordered my MBX6T kit and B5, haven't got it yet. I'm afraid that by the time I get everything and get it together, it's going to be too cold outside to break it in. Even if I use foil or a sock on the head.

Which brings up another question. If I'm not able to break in my B5 until spring, is there anything special I should do to the engine, since it will be basically sitting for a few months and not being ran? Will it be ok to sit like it is, or should I do something special with it? There won't be any fuel ran through it.

Thanks for the input, I appreciate it!!!