Originally Posted by
Mr.juarez
finally broke down for the savox low profile servo and im having a hard tine fitting it. It almost seems as if the holes that were drilled in the chassis for the front legs of the servo arm are too far in? The screws to bolt the servo arms go in at an angle instead straight up.
Also what spur in 48 or 64 pitch are you guys running with the stock diff ball or some different? I put the stock 93t spur that came with it and a 38 64 pitch pinion and they seem to mesh fine? That put me at 2.4fdr is this right or wrong?
With a Futaba lo-pro servo
It fit's ok, but only with thin servo tape
At most of the tracks in the UF1 series we gear 93x31-35
That's with 21.5 Blinky
3mm Ceramic diff balls are the only thing I add to the stock diff assy