Originally Posted by
MarkA
Are your lipos old and are you on throttle/accelerating when it cuts out? If so, you could be hitting the ESC's lipo cut when under a load. Also, perform the standard first step for throttle issues - replace the sensor cable.
New Lipo. after long full throttle run, stop, turn around, dead. 2 seconds later, ok. flat ground. Sensor wire is not very old? I think I have an sr3100 not an s3000. its a tiny little rx with a short antenna. I just re-BINDed the car and reset the ESC. turned the drag brake down, I was running the ESC in a 4wd. I'm going to do the internal temp readout at the track tonight. It wasn't even warm though. I'm running 18/87 gears in an SC10, Orion 10.5, I don't think there is any way it could be thermal-ing. My guess is the cap was draining from the drag brake? idk!!!