Originally Posted by
20967
Last weekend I have a big problem with setup in TC6; the problem is the most powerfull grip in the track, technical and small.
My car in the corners rolled away and I can not push for consistant lap time and for total race.
Here my set up
For additive I used CS High grip 20' in the rear 10' in front for the first race, then 10' in front e rear, and for last 5' in front e rear but without any best condition.
After I used LRP Carpet 2 with best result but the car are again difficult to drive without mistake.
I changed droop to 6.5 a 6 in the front and to 5.5 a 5 in the rear; lower shocks front and rear but I do not changed the arm mount for the available limited time in the qualification and final.
I have finished 9 in the "A" Final but I am not satisfied for my performance and for the work done on the car.
Any advice for me?
Less front additive would help in fine tuning but looking at your setup I think the car is too narrow especially in the front.
In the front I would run the offset mounts with a 1mm shim which will be an increase of 1.5mm per side over what you run now. You may even want to go wider. Leave the rear as is and widen in .5mm increment so help improve rotation in the center of the turn.
I don't recognize the body you use. It may or may not be the best option but for certain run a lightweight version.
Lower your ride height if the track is smooth enough.