R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 11-14-2012 | 11:26 AM
  #24011  
Aoh
Tech Regular
iTrader: (16)
 
Joined: Dec 2010
Posts: 425
From: So Cal
Default
Originally Posted by Wild Cherry
Hope your also using the Losi ball stud , if your using the Ae stud & the Losi ball cup ?

way tight & bind bad ....

BTW
If you did use the Ae stud and they are not binding ?
The losi cups are already worn out & and most likely the ball studs as well... ...
Switch to RPM & Ae stud , more betta


PS get your hex's hubs on there , whats the hold up ?
i kinda break them in by hand, so far so good, i dont pop links much unless its worn out, which only happens on the rear.

i definitely popped more links when i was running the rpm

not using hex fronts because i have too many front bearing wheels/tires. i also share the front wheels with my gold pan rc10
Aoh is offline  
Reply