Originally Posted by
Waflet
Hideho
Glitch buster
Yes, I forgot about nosing it in because I see my son tail it in & mash the mesh so often
, nosing it in will move the motor forward also. The idea with a buggy is to always be SMOOTH, but especially on the jumps (you break more stuff missing a jump than you do missing a corner
). If you quickly ease into the throttle before a jump & ease out a little during, your buggy will make a smooth arc from ramp to ramp, with the chassis starting parallel the launch ramp & end slightly nose down to the landing ramp (even if it is flat ground).
p.s. 1257 is a perfect fit, no spacers needed to mount it.
Oh I forgot to mention, I plan on getting the flysky gt3c, I would assume I don't need a glitch buster, but I'm going to get one for the heck of it. Where do I put it in my RX?
This is a little off topic, but my vorza as I explained earlier has BEC issues and the HPI support told me to get the castle creations BEC. Does that Spektrum Voltage Protector you linked me work the same? If so I might as well save some cash. And It doesn't matter if its spektrum right? Cause all my TX/RX aren't spektrum.