Originally Posted by
Odin544
To do that would you put the foam on the rim first, Then put the tire over the foam and rim? I've had issues with my pit shimizu foams bunching up on my F1 wheels. I started CA gluing the foam together where it butts together but the CA'ed foam creates a noticeable hard spot after its mounted. I may try this double sided tape idea out.
Put the tape on the rim, leaving the backing on the exposed side, dont overlap ends. Put the foam in the tire, then assembly on rim. Peel rear side of tire up enough to snag the tape backing with some tweezers or similar. slowly pull the tape backing out and the foam should set down on the now exposed sticky part.