Originally Posted by
Acill
Well SRS is well groomed hard pack with a bit of fluff, sticky when wet, loose when dry. Glitch is hard packed and loose on top. Not quite a loamy track but it does have some lose dirt on top of the hard pack at times.
The hacker 4 pole I have is the newest one. Its a 450 5.5 can. I also have a Tekin SC4X 4.5 I can put back in. What ESC settings in the RX8 do you recommend? I hate being suck a great driver indoor and then look like crap outdoor. Its not my lines, its just the speeds.
For the RX8, I run current limit @ 100 indoor and anywhere from 90 down to 75 outdoor.
That limits power sent to the motor for the first certain amount of rpm (not sure what that value is, maybe first 20%?) on the bottom end then goes to 100% power. Good in less than ideal traction situations like dry hard pack with a little loose dirt on top.
Timing for a 4 pole is zero. Two pole, time as temps allow.
4 pole FTW.
Push is set to 20. That keeps a hair of throttle on when you go to neutral so you roll through turns a little better... better flow for me. Go to any amount of brake and push is inactive.
Zero drag, preference like the push setting.
The rest like neutral width, min throttle- brake, brake strength and so on can be copied off the pro setups on the tekin site.
Make sure you're running the 2.23 firmware, there is a sc4-x specific pro sheet if you want to go back to the tekin and a couple 4 pole sheets (pro4) for your hacker.
http://www.teamtekin.com/hotwire/ESC...up-sheets.html