10R5.1 Build Tips
Im sure some of you will be building your new cars soon.
Here are some build tips that might help someone.
Chassis rails: The manual shows a tip for installing the nut inserts into the chassis rails. Add a 7-8mm O.D. washer on the button head screw and use it to install the inserts. Dont fully tighten the rails to the chassis until you have the rails in place.
Until a different front pin brace solution comes along, you can make a brace with chassis standoffs(#8535 and #4699), ballstud spacers and long set-screws. You will need to size the length of the brace to fit your upper arm length.
For carpet racing: The kit setup is a good starting, but add inline axles. If grip is high, try adding 2mm to the front upper arm length.
I cant believe the corner-speed the car has!
Last edited by Maybell; 11-12-2012 at 01:01 PM.