Razzo I ran the LW set on the 415 before making mods to accomodate foam.

To tell you the truth I liked it better then the E4 I just built for carpet 19T. I have not put a fair set-up on the E4 yet to say whih car is truly better.

As for setup here is where the car was

Front:
50wt 3hole
Tamiya Grey
Arm 3hole front, middle hole.
1mm droop
Shock Top outer hole
3mm under inner link.
Hinge blocks C/A
-1 camber
Blue Sway

Rear:
40wt 3hole
Tamiya White
Arm 3hole rear, middle hole.
2mm droop
Shock Top outer hole
1mm under inner link.
Hinge blocks A/B
-1.5 camber
Blue Sway

Tire ING25 Sorex B insert

For those having issues with the bearings have you cleaned them out of the factory grease. It has seemed that those who are cleaning and re-oiling are having the issues with the bearing. Not the best for efficiency but the factory grease seems to help the shock loads.