Originally Posted by
btsai
I run 16awg on mine since I run it in my CRC Xi.
For the timing, I use the programming card, set the timing to zero and the light blinks, just like it's supposed to.
As far as power goes -- seems to be fine. Note that RacinJ posted earlier in this thread (the same day he was running his car with an RS Pro ESC) and said my car ran fine.
Just sayin...
Good luck! (And get the programming card if you don't already have it. So easy.)
I just got my programming card. Apparently it was operating in sensorless mode. After putting it in sensored mode, the red LED blinks when motor timing is set at zero. And higher timing settings definitely have an effect on RPM. I'll have to re-test it on the dyno someday soon.