Hey, I have a Reventon R, ran it once so far and noticed it wasn't in blinky mode.

I tried to load the Stock 0 programming, the application detected my ESC and I clicked update, selected stock 0 V18 and then clicked ok, it went through the upload process and completed. I set the brake/drag, then set the voltage cutoff and it said everything was set correctly. Exited the software, disconnected the power and connected it back to my receiver, hooked it up to my lipo and turned it on. Got power to the servo and the fan was running just fine but when I pressed the throttle nothing happens now. Verified it wasn't a radio setting. Turned it off, connected to the programming card, checked settings and instead of just having the basic settings of like 1-11 or whatever it went up to 15 but everything over 11 was set to 0.

I turned it off, disconnected and tried to reconnect to my PC, now the programming card shows SP and then goes to -- and the software never detects the ESC, but the card itself is detected. Connecting it to my car only and then connecting the lipo it does the same thing.

Is it dead? Any special recovery mode I can try? I really hate to have to wait for over a month for it to ship back to wherever it came from and then wait for a new one to arrive. I think setting it to blinky mode should not kill it, Maybe want to look into a fix if any SP employees see this :-P