Originally Posted by
savannahmick
First thanks for helping me out guys! I have not really done much to the profile other than turn off dynamic and drag brake but I do have 95% brake and the wheels still aren't locking up so thats why I have it high. The timing is 0deg. on both accel. and top speed /brake freq. 6400/thr. freq. 6400/punch 30%/slew 15deg./SBEC 6.4/motor is at 15deg./ and geared 21/81 in a b4.1 no bind smooth as silk. Any ideas on what I could do to get temps down just a little on esc. with the settings? 160f on ESC and 150f motor 8.5 vst. Thanks!
Looking at the settings / gearing I think you are under-geared almost 15%
Your roll-out would be a 1.08"
Many of the AE drivers run 7.5 motors and run either 22/78 or 22/81, and on my B4 with a VST8.5 / VTX10R-BE I am running 23/81. My roll out is at 1.18"
I would suggest going up at least one tooth, turn down the brake freq to 2500 or 4000hz, and turn the motor back to stock timing. Set the end point at 80% on the throttle and start testing there. Again, set the motor and esc temp settings ESC 170 and motor 200.