Originally Posted by
Cain
I actually would be curious to see the other two chassis pieces in alloy to see how the vehicle performs]
You could also make a chassis that will accept stick packs down the middle as well as the mounting hardware to do that. I bet that could go over really well. Machine your chassis so that using sticks ESCs have more room to fit.
Possibly machine the chassis so the batteries sit lower (assuming this is a possibility) on the chassis.
+1... good thought.
To take it a step further...
Why a 3 piece chassis at all?
Why not make a one piece chassis?
I don't know anyone that will pull the front or rear section to replace with another section fully built just to change setup or whatever AE thought we would need a modular chassis like that for
Good bye torsional twist
