Originally Posted by
jarrodh
its the same size bearing as the old cars.. dont know the exact measurements off hand..
could be out of level.. but its pretty damn close with my mic... and both times it was the same side/bearing
i think that now the bearing are mounted in aluminum, rather than the plastic inserts of the older cars, that there is no give anymore.. and that little collar/spacer between the hub and the bearing just drives the center race out everytime theres contact.. ive never in all my years runnin crc cars even blown a rear axle bearing, nevermind 2 exploding in the same night, back to back.
im goin to see if i can get/make a washer that is the same O.D as the bearing, maybe itll hit flat rather then punch the center out..?
Sounds like a recipe to create a bind in corners as the axle will no longer have an effective bearing on the outside.