Setup I ran on the weekend. Had tons of steering
Front
Downstops 0mm
Ride Height 5mm
Camber L & R -2
Track Width 199mm
Toe in -.5
Caster 3mm
RC 0mm under (Highest)
Upstop N/A
Shocks 2 Holes 40W Serpent Tower Position 3
Springs Red
Roll Bar Flat
Rear
Downstops 7mm
Ride Height 5mm
Camber L & R -3
Track Width 200mm
Toe in 2
RC Upper Upper Inner
RC Lower Low
Shocks 5 Holes 40W Serpent Tower Position 1 Lower position outer
Roll Bar 5mm in. Standard bar
Tyres Speedmind 35's Front and rear
Rear Axle Diff set soft
Trans 17 & 21 Spurs Standard
Body Protoform Mazda 6
Others
New servo saver
Alu Shocks
New Serpent engine mount
Alu X member
Alu Bracket middle shaft
Serpent Alu Roll Bar levers
CF Front bumper
bearing spacers in hubs
Engine NSR 3
Clutch Standard setting with yellow shoe
For me the car was a little loose in the rear but the track had poor grip. The reaction of the car was incredible. Super responsive. Will try harder front bar next meeting and possibly harder front tyres
Last edited by Picard; 10-04-2004 at 10:41 PM.