R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 10-19-2012 | 05:02 PM
  #30544  
Cain's Avatar
Cain
Tech Legend
iTrader: (304)
 
Joined: May 2002
Posts: 35,029
From: West Fargo, North Dakota
Default
Originally Posted by Prostreet314
Cain, Manits, WC, correct me if I'm wrong but I believe they are reffering to the pinned rear topshaft kit. You need a top shaft with a hole drilled in it, a pin to fit that hole and a back slipper plate with a grove machined into it to fit over the pin. Locks the slipper together for front and rear drive. Fastlapproducts.net makes one
that sounds right to me but I haven't tried that setup since i run the center diff.
Cain is offline  
Reply