Originally Posted by chopper82p

The 1233sg is a tall servo so you will most likely have problems with it fitting in the car. I made the mistake and bought it not knowing it was tall, tried to install it in my truggy and was what its called, tall. Maybe you can use some spacers and long screws but that would make your linkage high and probably uneven.

I ran a Savox 1258 for a day. Only because I switched to HV servos and went with Hitec. The savox worked fine, and I haven't had problems with it but I've seen a few people have their Savox servos fail on them. Not saying they are bad, they are good servos with good specs, I only ran mine for a few minutes so I can't say anything about durability/lifetime.