R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 10-11-2012 | 08:21 PM
  #22133  
Eli's Avatar
Eli
Tech Master
iTrader: (15)
 
Joined: Apr 2010
Posts: 1,553
From: San Diego, CA.
Default
Originally Posted by Wildcat1971
how is it useless? I run 2 washers and the A Hubs. If I went no washers and C hub, it would raise my roll center, but camber gain would be the same. Raising and lower the stud is camber gain, everyone running the 2mm lower rod is increasing roll center.
Running the c hub with no shaved brace is a lower roll center then the A hub with 2 washers.
Eli is offline  
Reply